We present a compilation of tropospheric 14CO2 for the period 1950–2010, based on published radiocarbon data from selected records of atmospheric CO2 sampling and tree-ring series. This compilation is a new version of the compilation by Hua and Barbetti (2004) and consists of yearly summer data sets for zonal, hemispheric, and global levels of atmospheric 14C. In addition, compiled (and extended) monthly data sets for 5 atmospheric zones (3 in the Northern Hemisphere and 2 in the Southern Hemisphere) are reported. The annual data sets are for use in regional and global carbon model calculations, while the extended monthly data sets serve as calibration curves for 14C dating of recent, short-lived terrestrial organic materials.

Recent measurements on dendrochronologically-dated wood from the Southern Hemisphere have shown that there are differences between the structural form of the radiocarbon calibration curves from each hemisphere. Thus, it is desirable, when possible, to use calibration data obtained from secure dendrochronologically-dated wood from the corresponding hemisphere. In this paper, we outline the recent work and point the reader to the internationally recommended data set that should be used for future calibration of Southern Hemisphere 14C dates.

In this paper, we summarize the main chemical pretreatment protocols currently used for AMS radiocarbon dating at the Oxford Radiocarbon Accelerator Unit, updating the protocols last described by Hedges et al. (1989).

The definitive paper by Stuiver and Polach (1977) established the conventions for reporting of radiocarbon data for chronological and geophysical studies based on the radioactive decay of 14C in the sample since the year of sample death or formation. Several ways of reporting 14C activity levels relative to a standard were also established, but no specific instructions were given for reporting nuclear weapons-testing (post-bomb) 14C levels in samples. Because the use of post-bomb 14C is becoming more prevalent in forensics, biology, and geosciences, a convention needs to be adopted. We advocate the use of fraction modern with a new symbol F14C to prevent confusion with the previously used Fm, which may or may not have been fractionation-corrected. We also discuss the calibration of post-bomb 14C samples and the available data sets and compilations, but do not give a recommendation for a particular data set.

Calibration curves spanning several millennia are now available in this special issue of R adiocarbon. These curves, nearly all derived from the 14C age determinations of wood samples, are to be used for the age conversion of samples that were formed through use of atmospheric CO2. When samples are formed in reservoirs (eg, lakes and oceans) that differ in specific 14C content from the atmosphere, an age adjustment is needed because a conventional 14C age, although taking into account 14C (and 13C) fractionation, does not correct for the difference in specific 14C activity (Stuiver & Polach, 1977). The 14C ages of samples grown in these environments are too old, and a reservoir age correction has to be applied. This phenomenon has been referred to as the reservoir effect (Stuiver & Polach, 1977).

We have measured radiocarbon in prebomb known-age shells and coral from the Indian Ocean and southeast Asia to determine marine reservoir age corrections. Western Indian Ocean results show a strong 14C depletion due to upwelling in the Arabian Sea, and indicate that this signal is advected over a wide area to the east and south. In contrast, the surface waters of the South China Sea contain relatively high levels of 14C, due in part to the input of well-equilibrated water masses from the western Pacific. The easternmost regions of the Indian Ocean are also strongly influenced by the flowthrough of Pacific waters north of Australia.

The calibration curves and tables given in this issue of RADIOCARBON form a data base ideally suited for a computerized operation. The program listed below converts a radiocarbon age and its age error os (one standard deviation) into calibrated ages (intercepts with the calibration curve), and ranges of calibrated ages that correspond to the age error. The standard deviation oC in the calibration curve is taken into account using (see Stuiver and Pearson, this issue, for details).

A comprehensive tropospheric 14CO2 data set of quasi-continuous observations covering the time span from 1959 to 2003 is presented. Samples were collected at 3 European mountain sites at height levels of 1205 m (Schauinsland), 1800 m (Vermunt), and 3450 m asl (Jungfraujoch), and analyzed in the Heidelberg Radiocarbon Laboratory. The data set from Jungfraujoch (1986–2003) is considered to represent the free tropospheric background level at mid-latitudes of the Northern Hemisphere, as it compares well with recent (yet unpublished) measurements made at the marine baseline station Mace Head (west coast of Ireland). The Vermunt and Schauinsland records are significantly influenced by regional European fossil fuel CO2 emissions. The respective Δ14CO2 depletions, on an annual mean basis, are, however, only 5 less than at Jungfraujoch. Vermunt and Schauinsland both represent the mean continental European troposphere.

Graphite in various forms has become the standard target for accelerator 14C dating. Graphite has been made by catalytic graphitization of charcoals (Lowe, 1984). Thin films of graphite have also been produced by thermal cracking (Beukens & Lee, 1981), electric discharge (Andrée et al, 1984; Wand, Gillespie & Hedges, 1984). Vogel et al (1984) pointed out the ease of graphite formation on iron from CO2 and H2 mixtures at ca 600°C. The deposition reactions of carbon from the CO, H2, and CO2 equilibria are well known (Wagman et al, 1945) and well studied. Formation of graphite from CO2 was discussed extensively by Boudouard (1902) and Schenck and Zimmerman (1903), and was known to chemists in France in 1851. We have used a related method, where graphite forms away from the iron, by using a higher temperature, and reduction of CO2 to CO over Zn in the presence of H2 (Jull et al, 1986) as an alternative to the use of Fe alone. The object of this paper is to point out an even simpler graphite preparation system, which eliminates hydrogen. The decomposition reaction of CO (Boudouard, 1902) takes place according to reaction (1).

Bone is one of the most widely used materials for dating archaeological activity. It is also relatively difficult to pretreat effectively and new methods are an area of active research. The purpose of the chemical pretreatment of bone is to remove contaminants present from burial and to do so in a way which does not add any additional laboratory contaminant. To some extent, these two aims must be balanced since, on the whole, the more complex the procedure and the more steps included, the greater the chance for contamination. At the Oxford Radiocarbon Accelerator Unit (ORAU), the method used is a continuous-flow or manual acid/base/acid (ABA) treatment followed by gelatinization and ultrafiltration (based on Brown et al. [1988]; documented in Bronk Ramsey et al. [2000]). We find this overall method is very effective at removing more recent contamination in old bones. However, two aspects of the method have recently been improved and are reported here: the redesign of ORAU's continuous flow pretreatment and a new protocol in our pretreatment ultrafiltration stage.

Radiocarbon ages of dendrochronologically-dated wood spanning the last 4500 years were determined at both the Seattle and Belfast laboratories. The combined results are reported in this issue of radiocarbon in two papers, with this paper covering the AD 1950—500 BC interval, and the twin (Pearson & Stuiver, 1986) covering the 500 BC–2500 BC interval.

Comprehensive published radiocarbon data from selected atmospheric records, tree rings, and recent organic matter were analyzed and grouped into 4 different zones (three for the Northern Hemisphere and one for the whole Southern Hemisphere). These 14C data for the summer season of each hemisphere were employed to construct zonal, hemispheric, and global data sets for use in regional and global carbon model calculations including calibrating and comparing carbon cycle models. In addition, extended monthly atmospheric 14C data sets for 4 different zones were compiled for age calibration purposes. This is the first time these data sets were constructed to facilitate the dating of recent organic material using the bomb 14C curves. The distribution of bomb 14C reflects the major zones of atmospheric circulation.

In 1988, Fairbanks conducted a drilling expedition off the south coast of Barbados to recover submerged corals contemporaneous with the last deglaciation. Core recovery was excellent and >30 different samples were dated by conventional β-counting techniques (Fairbanks 1989). At about the same time, we developed, at Lamont, the thermal ionization mass spectrometry (TIMS) technique to obtain precise U-Th ages (Edwards 1988), and to compare them with the 14C estimates measured on the same samples. A surprising result was that the discrepancy between 14C and U-Th ages increased through time to ca. 3000–3500 yr at ca. 15,000 14C BP (Bard et al. 1990a). Because the three youngest samples yielded U-Th ages in agreement with their calibrated 14C ages, we concluded initially that the TIMS U-Th determinations were not only precise, but also accurate, and that the 14C vs. U-Th data set could be used for a first-order 14C calibration.

Three modes of reporting 14C activities are in use, in part analogous to the internationally accepted (IAEA) conventions for stable isotopes: (1) absolute activity, the specific activity of 14C or the activity per gram of carbon; (2) activity ratio, the ratio between the absolute activities of a sample and the standard; and (3) relative activity, the difference between the absolute activities of a sample and standard material, relative to the absolute standard activity. The basic definitions originate from decisions made by the radiocarbon community at its past conferences. Stuiver and Polach (1977) reviewed and sought to specify the definitions and conventions. Several colleagues, however, have experienced inadequacies and pitfalls in the definitions and use of symbols. Furthermore, the latter have to be slightly amended because of the use of modern measuring techniques.

This paper is intended to provide a consistent set of reporting symbols and definitions, illustrated by some practical examples.

We propose a simplified approach to the calibration of radiocarbon dates. We use splines through the tree-ring data as calibration curves, thereby eliminating a large part of the statistical scatter of the actual data points. To express the age range, we transform the ± 1 σ and ± 2 σ values of the BP age to calendar dates and interpret them as the 68% and 95% confidence intervals. This approach bypasses the conceptual problems of the transfer of individual probability values from the radiocarbon to the calendar age. We have adapted software to make this calibration possible.

The Oxford Radiocarbon Accelerator Unit (ORAU) has used an ultrafiltration protocol to further purify gelatin from archaeological bone since 2000. In this paper, the methodology is described, and it is shown that, in many instances, ultrafiltration successfully removes low molecular weight contaminants that less rigorous methods may not. These contaminants can sometimes be of a different radiocarbon age and, unless removed, may produce erroneous determinations, particularly when one is dating bones greater than 2 to 3 half-lives of 14C and the contaminants are of modern age. Results of the redating of bone of Late Middle and Early Upper Paleolithic age from the British Isles and Europe suggest that we may need to look again at the traditional chronology for these periods.

This paper covers three different methods of matching radiocarbon dates to the ‘wiggles’ of the calibration curve in those situations where the age difference between the 14C dates is known. These methods are most often applied to tree-ring sequences. The simplest approach is to use a classical Chi-squared fit of the 14C data to the 14C curve. This gives the calendar date where the data fit best and allows tests of how good the fit is. The only drawback of this method is that it is difficult to ascertain the uncertainty in the date found in this way. An extension of this technique uses a Monte-Carlo simulation to sample possible 14C concentrations consistent with the measurement made and for each of these possibilities performs a Chi-squared fit. This method yields a distribution of values in the calendrical time-scale, from which the overall dating uncertainty can be derived. A third, rather different approach, based on Bayesian statistics, calculates the relative likelihood of each possible calendar year fit. This can then be used to calculate a range of most likely dates in a similar way to the probability method of 14C calibration. The theories underlying all three methods are discussed in this paper and a comparison made for the fitting of specific model sequences. All three methods are found to give consistent results and the application of any one of them depends on the nature of the scientific question being addressed.

We present here the method we use to convert to radiocarbon ages (14C/13C) ratios measured in the Arizona Accelerator Mass Spectrometer facility. We describe the procedures we use to convert sample and standard isotope ratios to values appropriate for calculation of radiocarbon ages. We also discuss, in some detail, corrections to account for sample contamination.

We measured apparent marine radiocarbon ages for the Mediterranean Sea, Black Sea, and Red Sea by accelerator mass spectrometry radiocarbon analyses of 26 modern, pre-bomb mollusk shells collected living between AD 1837 and 1950. The marine reservoir (R(t)) ages were estimated at some 390 ± 85 yr BP, 415 ± 90 yr BP and 440 ± 40 yr BP, respectively. R(t) ages in the Mediterranean Sea and Black Sea are comparable to those for the North Atlantic Ocean (<65°N), in accordance with the modern oceanic circulation pattern. The ΔR values of about 35 ± 70 yr and 75 ± 60 yr in the Mediterranean area show that the global box-diffusion carbon model, used to calculate R(t) ages, reproduces the measured marine 14C R(t) ages in these oceanic areas. Nevertheless, high values of standard deviations, larger than measurement uncertainties are obtained and express decadal R(t) changes. Such large standard deviations are indeed related to a decrease of the apparent marine ages of some 220 yr from 1900 AD to 1930 AD in both the Mediterranean Sea and the western North Atlantic Ocean.

Climate on Earth strongly depends on the radiative balance of its atmosphere, and thus, on the abundance of the radiatively active greenhouse gases. Largely due to human activities since the Industrial Revolution, the atmospheric burden of many greenhouse gases has increased dramatically. Direct measurements during the last decades and analysis of ancient air trapped in ice from polar regions allow the quantification of the change in these trace gas concentrations in the atmosphere. From a presumably “undisturbed” preindustrial situation several hundred years ago until today, the CO2 mixing ratio increased by almost 30% (Figure 1a) (Neftel et al. 1985; Conway et al. 1994; Etheridge et al. 1996). In the last decades this increase has been nearly exponential, leading to a global mean CO2 mixing ratio of almost 370 ppm at the turn of the millennium (Keeling and Whorf 1999).