Hostname: page-component-cb9f654ff-c75p9 Total loading time: 0 Render date: 2025-08-18T22:12:36.261Z Has data issue: false hasContentIssue false
  • English
  • Français

Development of a simple device for a moisture-proof X-ray diffraction analysis

Published online by Cambridge University Press:  10 January 2013

Chi-Tang Li
Chi-Tang Li
Affiliation:
Dow Corning Corporation, Midland, Michigan 48686-0994
Get access Rights & Permissions [Opens in a new window]

Abstract

A simple device was developed for a moisture-proof X-ray diffraction analysis. The device consists of a simple plastic ring where one side was glued on with a thin film to let in the X-ray beam and the other side was covered with grease to seal onto a base plate. This device was later optimized by selecting a good adhesive to glue on the film, a very effective film to minimize the moisture intake, and an optimum ring height to maximize the X-ray intensity. Finally, this simple device was successfully verified that it can protect the anhydrous CaCl2 (hydrophilite) up to 4 days in ambient air.

Information

Type
Research Article
Information
Powder Diffraction , Volume 12 , Issue 3 , September 1997 , pp. 145 - 150
Copyright
Copyright © Cambridge University Press 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

Oesterholm, H., and Vilhunen, J. (1991). “Some Sample Preparation Methods for Powder Diffraction at Neste Oy,” Mater. Sci. Forum 79–82, 959–964.CrossRefGoogle Scholar