Hostname: page-component-745bb68f8f-d8cs5 Total loading time: 0 Render date: 2025-02-04T16:51:01.064Z Has data issue: false hasContentIssue false
  • English
  • Français

Studies Of Cement Grouts And Grouting Techniques For Sealing A Nuclear Fuel Waste Disposal Vault

Published online by Cambridge University Press:  22 February 2011

Maria Onofreic ,
Malcolm N. Gray ,
L. Douglas Keil  and
Roland Pusch
Maria Onofreic
Affiliation:
Atomic Energy of Canada Limited, Whiteshell Nuclear Research Establishment, Pinawa, Manitoba, Canada ROE 1L0
Malcolm N. Gray
Affiliation:
Atomic Energy of Canada Limited, Whiteshell Nuclear Research Establishment, Pinawa, Manitoba, Canada ROE 1L0
L. Douglas Keil
Affiliation:
Atomic Energy of Canada Limited, Whiteshell Nuclear Research Establishment, Pinawa, Manitoba, Canada ROE 1L0
Roland Pusch
Affiliation:
Clay Technology AB, IDEON Research Center, S-223 70 Lund, Sweden
Get access

Abstract

A cement-based grout (90% Type 50, 10% silica fume, 0.4 < water-to-cement ratio, w/c < 0.6) has been used in field trials at AECL's Underground Research Laboratory in Canada and at the OECD/NEA Stripa Mine in Sweden, to evaluate suitable grouts and grouting techniques that could be used for sealing a nuclear fuel waste disposal vault mined deep in granite. Laboratory studies have been carried out to determine the following grout properties: hydraulic conductivity (k); resistance to piping and erosion during setting; influence of grout on the pH and chemical composition of water permeating grouted rock; and the ability of the grout to self-seal after fracturing.

Laboratory tests have confirmed the low intrinsic k of these cement mixtures (10−14 m/s). Using a specially developed cone-in-cone apparatus, we have studied the effect of fracture dilation and temperature changes on the k of thin films of cement. If fractured, the grout has an ability to self-seal and the rate of self-sealing increases with increasing temperature.

The pH and ionic composition of the water permeating grouted fractured granite rock were found to vary with grouted fracture aperture and grout/rock volume ratio. The field tests demonstrated that grout can penetrate and seal very fine fissures (apertures less than 50 μm).

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 137: Symposium P – Pore Structure and Permeability of Cementitious Materials , 1988 , 349
Copyright
Copyright © Materials Research Society 1989

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Hancox, V. T., CNA/CNS Annual Conference, Winnipeg, Manitoba (1988).Google Scholar
2. Pusch, R., Interim Report on the Rock Sealing Project (Stage 1), SKB September (1988).Google Scholar
3. Coons, E. W., International Technology Corporation Report, July (1987).Google Scholar
4. Pusch, R., Stripa Project 88-08 SKB, Box 5864 48 Stockholm (1988).Google Scholar
5. Ballivy, G., Bulletin of the Int. Assoc. of Engineering Geology, No. 37, pp. 3–9 (1988).Google Scholar
6. Seymour, P. H., Gray, M. N. and Cheung, S. C. H., Geotechnical and Geohydrological Aspects of Waste Management, Balkema Publishers Limited, Boston (1986).Google Scholar
7. Pusch, R., Workshop on Excavation Response in a Deep Radioactive Waste Repository, Winnipeg, Manitoba, April 26–27, 1988.Google Scholar
8. Lau, D. and Crawford, A., ISBN 0-7724-7082-4, University of Toronto, Department of Civil Engineering.Google Scholar
9. Gray, M.N. and Keil, L.D., to be published in 3rd International Conference on Superplasticizers and Chemical Admixtures in Concrete, Ottawa, October 4–6, 1989.Google Scholar