Hostname: page-component-745bb68f8f-cphqk Total loading time: 0 Render date: 2025-02-04T13:44:01.637Z Has data issue: false hasContentIssue false
  • English
  • Français

Sol–Gel-Derived 0–3 Composite Materials for Direct Write Electronics Applications

Published online by Cambridge University Press:  10 February 2011

Steven M. Coleman ,
Robert L. Parkhill ,
Robert M. Taylor  and
Edward T. Knobbe
Steven M. Coleman
Affiliation:
Thin Film and Materials Processing Group, Department of Chemistry, Oklahoma State University, Stillwater, OK, U.S.A., 74078 CMS Technetronics, Inc., 5202-2 North Richmond Hill Road, Stillwater, OK, U.S.A., 74075
Robert L. Parkhill
Affiliation:
CMS Technetronics, Inc., 5202-2 North Richmond Hill Road, Stillwater, OK, U.S.A., 74075
Robert M. Taylor
Affiliation:
CMS Technetronics, Inc., 5202-2 North Richmond Hill Road, Stillwater, OK, U.S.A., 74075
Edward T. Knobbe
Affiliation:
Thin Film and Materials Processing Group, Department of Chemistry, Oklahoma State University, Stillwater, OK, U.S.A., 74078
Get access

Abstract

The use of sol–gel-derived 0–3 composite ceramics for low-temperature direct-write electronics applications was investigated. The 0–3 composite paste materials were prepared using selected metal alkoxides and commercial low- and high-κ' dielectric powders. The composite pastes were deposited onto alumina and polyimide substrates using conventional screening and micro-dispensing techniques. The deposited films were oven-dried at or below 200°C and thermally densified using a CO2 laser. The 0–3 composites exhibited good adhesion and structural density. Electrical characterization of the laser-processed dielectrics revealed κ' values as high as 295 and tan δ as low as 0.02 on polyimide substrates.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 624: Symposium V – Materials Development for Direct Write Technologies , 2000 , 53
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 Barrow, D. A., Petroff, T. E., Tandon, R. P., and Sayer, M., J. Appl. Phys. 81, p. 876 (1997).Google Scholar
2 Barrow, D. A., Petroff, T. E., and Sayer, M., J. Surf. Coat. Technol. 76–77, p. 113 (1995).Google Scholar
3 Barrow, D. A., Petroff, T. E., and Sayer, M., Mat. Res. Soc. Symp. Proc. 60, p. 103 (1995).Google Scholar
4 Yi, G. and Sayer, M., Ceramic Bulletin, 70, p. 1173 (1991).Google Scholar