Hostname: page-component-5b777bbd6c-2c8nx Total loading time: 0 Render date: 2025-06-19T16:18:54.578Z Has data issue: false hasContentIssue false
  • English
  • Français

Metastable Phase Formation and Microstructural Evolution During Self-Propagating Reactions in Ai/Ni and Ai/Monel Multilayers

Published online by Cambridge University Press:  10 February 2011

D. Van Heerden ,
A. J. Gavens ,
S. Jayaraman  and
T. P. Weihs
D. Van Heerden
Affiliation:
Materials Science and Engineering Department, The Johns Hopkins University, 3400 N. Charles Street, Baltimore MD 21218, DPV1@JEIUVMS.HCF.JHU.EDU
A. J. Gavens
Affiliation:
Materials Science and Engineering Department, The Johns Hopkins University, 3400 N. Charles Street, Baltimore MD 21218, DPV1@JEIUVMS.HCF.JHU.EDU
S. Jayaraman
Affiliation:
Materials Science and Engineering Department, The Johns Hopkins University, 3400 N. Charles Street, Baltimore MD 21218, DPV1@JEIUVMS.HCF.JHU.EDU
T. P. Weihs
Affiliation:
Materials Science and Engineering Department, The Johns Hopkins University, 3400 N. Charles Street, Baltimore MD 21218, DPV1@JEIUVMS.HCF.JHU.EDU
Get access

Abstract

The quenched microstructures of self-propagating reactions in Al/Ni and Al/Monel foils are examined. The quenched reaction fronts in both films are shown to be approximately 30μm long and exhibit a continuous evolution from an as-deposited to a fully reacted microstructure. In both multilayers the first phase to form is isostructural with Al9Co2, and nucleates on the Al side of the layer interface. Growth of the intermetallic occurs in a two step process. First the grains grow laterally along the interface until they impinge on each other, followed by growth normal to the interface into the Al layer. It is shown that planarity of this interface during the latter growth stage is determined by the width of the intermetallic grains immediately prior to their growth normal to the interface into the Al layer. On the basis of these observations it is argued that in modeling these reactions diffusion through the intermetallic during the reaction must be considered, and that atomic diffusion may be considerably more three- dimensional in practice than the current models suggest.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 481: Symposium P – Science and Technology of Semiconductor Surface Preparation , 1997 , 533
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

REFERENCES

1. Weihs, T.P. in Handbook of Thin Film Processing Technology, Part B, Section F.7.Google Scholar
2. Mann, A.B., Gavens, A.J., Reiss, M.E., Van Heerden, D., Bao, G. and Weihs, T.P., J. Appl. Phys. 82 (3), 1178 (1997).Google Scholar
3. Jayaraman, S., Mann, A. B., Knio, O.M., Bao, G. and Weihs, T.P., submitted to this symposium.Google Scholar
4. Jayaraman, S., Mann, A.B., Weihs, T.P. and Knio, O.M., submitted to 27th International Combustion Symposium, Boulder, Co (1998).Google Scholar
5. Ma, E., Thompson, C.V., Clevenger, A. and Tu, K.N., Appl. Phys. Lett., 57 (12), 1262 (1990).Google Scholar
6. Jiang, H.G., Tong, H.Y., Xue, X.M., Ding, D.Z., Song, Q.H., Hu, Z.Q. and Yang, J.T., J. Mater. Scie. Lett., 12, 1687 (1993).Google Scholar
7. Anselmi-Tamburini, U. and Munir, Z.A., J. Appl. Phys. 66 (10), 5039 (1989).Google Scholar
8. Ma, E., Thompson, C.V. and Clevenger, L.A., J. Appl. Phys. 69 (4), 2211 (1991).Google Scholar
9. Barmak, K., Michealson, C. and Lucadamo, C., J. Mater. Res., 12 (1), 133 (1997).Google Scholar
10. Edelstein, A.S., Everett, R.K., Richardson, G.Y., Qadri, S.Q., Altman, E.I., Foley, J.C. and Perepezko, J. H., J. Appl. Phys. 76 (12) 7850 (1994).Google Scholar
11. Van Heerden, D., Gavens, A.J., Jayaraman, S. and Weihs, T.P., to be submitted to J. Mater.Res.Google Scholar
12. Perepezko, J.H. and Furrer, D.U. in Dispersion Strengthened Aluminum Alloys, edited by Kim, Y.- W. and Griffith, W. M. (TMS-AIME, Warrendale, PA, 1988), p. 77.Google Scholar