Published online by Cambridge University Press: 26 February 2011
The dual ion implantation of Ti and C into 304 stainless steel has been found to reduce friction and wear in ultrahigh vacuum (UHV). The implantation treatment producing this result, 4.6 × 1017 Ti/cm2 (180 keV) followed by 2.0 × 1017 C/cm2 (50 keV), produced TiC precipitates dispersed in an amorphous surface layer. Friction and wear track compositions were measured in situ with a scanning Auger microprobe without removing the pin from the track. This treatment decreased the friction coefficient from 1.2 to 0.6–0.8 and the wear track width from 342 μm to 225 pm after 1000 cycles. Relative to unimplanted 304, wear tracks formed in UHV and air on implanted ‘304 had more N and less C. Oxygen and the metallic elements were similar in concentration, except for the presence of implanted Ti. Friction coefficients measured in air were less than those in UHV; track composition suggests that oxides or adsorbed moisture helped lower the friction in air.
This work was supported by the U. S. Department of Energy (DOE), under Contract Number DE-AC04-76-DP00789.
To send this article to your Kindle, first ensure no-reply@cambridge.org is added to your Approved Personal Document E-mail List under your Personal Document Settings on the Manage Your Content and Devices page of your Amazon account. Then enter the ‘name’ part of your Kindle email address below. Find out more about sending to your Kindle. Find out more about saving to your Kindle.
Note you can select to save to either the @free.kindle.com or @kindle.com variations. ‘@free.kindle.com’ emails are free but can only be saved to your device when it is connected to wi-fi. ‘@kindle.com’ emails can be delivered even when you are not connected to wi-fi, but note that service fees apply.
Find out more about the Kindle Personal Document Service.
To save this article to your Dropbox account, please select one or more formats and confirm that you agree to abide by our usage policies. If this is the first time you used this feature, you will be asked to authorise Cambridge Core to connect with your Dropbox account. Find out more about saving content to Dropbox.
To save this article to your Google Drive account, please select one or more formats and confirm that you agree to abide by our usage policies. If this is the first time you used this feature, you will be asked to authorise Cambridge Core to connect with your Google Drive account. Find out more about saving content to Google Drive.