Hostname: page-component-cb9f654ff-5jtmz Total loading time: 0 Render date: 2025-09-04T20:57:03.124Z Has data issue: false hasContentIssue false
  • English
  • Français

Improvement of productivity by stand-support sintering in commercial sintering machines

Published online by Cambridge University Press:  25 October 2002

K. Higuchi ,
T. Kawaguchi ,
M. Kobayashi ,
Y. Hosotani ,
K. Nakamura ,
K. Iwamoto  and
M. Fujitomo
Get access

Abstract

“Stand-support sintering”, that is supporting the load of the sinter cake with bars or plates attached to pallets, has been developed and applied practically to the sintering machines in Kimitsu works, Nippon Steel. The stands start to support the load of the sinter cake just after the top layer is melted and starts to solidify. Shrinkage is stopped and the gas flow rate is increased when the stands start to support the load of the sinter cake. It was found that sintering time was shortened and productivity was improved in actual sintering machines.

Information

Type
Research Article
Information
Metallurgical Research & Technology , Volume 99 , Issue 3: AgglomérationHaut-FourneauCokerie , March 2002 , pp. 241 - 248
Copyright
© La Revue de Métallurgie, 2002

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable