Hostname: page-component-54dcc4c588-dbm8p Total loading time: 0 Render date: 2025-09-12T13:51:11.771Z Has data issue: false hasContentIssue false
  • English
  • Français

Separation of Internal Strains and Lattice Distortion Caused by Oxygen Impurities in Aluminum Nitride Hot-Pressed Ceramics

Published online by Cambridge University Press:  06 March 2019

O. N. Grigoriev ,
S. M. Kushnerenko ,
K. A. Plotnikov  and
W. Kreher
O. N. Grigoriev
Affiliation:
Department of Structural Ceramics Institute for Problems of Materials Science 3 Krzhizhanovskiy St., Kiev 252180, Ukraine
S. M. Kushnerenko
Affiliation:
Department of Structural Ceramics Institute for Problems of Materials Science 3 Krzhizhanovskiy St., Kiev 252180, Ukraine
K. A. Plotnikov
Affiliation:
Department of Structural Ceramics Institute for Problems of Materials Science 3 Krzhizhanovskiy St., Kiev 252180, Ukraine
W. Kreher
Affiliation:
Max-Plank-Society, Work Group of Heterogeneous Solid Mechanics, Engineering University of Dresden 3 Hallwachs St., D-01069, Dresden, Germany
Get access

Extract

Recently aluminum nitride (A1N) has been intensively studied as a promising material for production of hybrid integrated circuit substrates because of its high thermal conductivity, high fjexural strength, and nontoxic nature. The estimated theoretical value of its thermal conductivity at room temperature is 320 W/mK, but it is strongly degraded by the introduction of oxygen. The measured values vary from 30 to 260 W/mK, Therefore, in production of this material the reduction of oxygen contamination is of paramount importance.

Information

Type
V. Residual Stress, Crystallite Size and rms Strain Determination by Diffraction Methods
Information
Advances in X-Ray Analysis , Volume 38: Forty-third Annual Conference on Applications of X-ray Analysis , 1994 , pp. 479 - 487
Copyright
Copyright © International Centre for Diffraction Data 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

1. Slack, G. A., “Nonmetallic Crystals with High Thermal Conductivity,”. J. Phys. Chem. Solids, 34, 321–35 (1973).Google Scholar
2. Kurokawa, Y., Utsumi, K. and Takamizawa, H., “Development and Microstructural Characterization of High-Thermal-Conductivity Aluminum Nitride Ceramics,” J. Am. Ceram. Soc. 71, 7, 588–94 (1958).Google Scholar
3. Braudeau, Ph., Cales, B., Torre, J.P., “Microstructure Development in Sintered Aluminum Nitride,” Science of Ceramics, Free. 14th Int. Conf., Canterbury, 14, 413–18 (1988).Google Scholar
4. Lee, R. R., “Development of High Thermal Conductivity Aluminum Nitride Ceramic,” J. Am. Ceram. Soc, 74 (9), 2242–49 (1991).Google Scholar
5. Tsubouchi, K., Sugai, S., Mikoshiba, N., Ultmson. Symp. Proc, IEEE, 1, 375–80 (1981).Google Scholar
6. Jack, K.H., “Sialons and Related Nitrogen Ceramics,” J. Mater. Set., 11, 6, 1135–58 (1976).Google Scholar
7. Kreher, W., A. Molinary, “Residual Stresses in Polycrystals as Influenced by Grain Shape and Texture,” J. Mech. Phys. Solids, 41, 12, 1955–77 (1993).Google Scholar
8. Kreher, W., “Residual Stresses and Stored Elastic Energy of Composites and Polycrystals,“ J. Mech. Phys. Solids, 38, 1, 115–28 (1990).Google Scholar
9. Youngman, R. A., Harris, J. H., “Luminescence Studies of Oxygen-Related Defects in Aluminum Nitride,” J. Am. Ceram. Soc., 73, 11, 3238–46 (1990).Google Scholar
10. Kheyker, D. M., Zevin, L. S., “X-Ray Diffraction (in Russian),” Metallurgy Press, Moscow (1963).Google Scholar
11. Krell, A., Grjgoriev, O. N., “Residual Stresses and Microporousity in Oxide Ceramics (in German),” Sprechsaal, 123, 10, 1012-15.Google Scholar
12. Blendell, J. E., Coble, R. L., “Measurement of Stress Due to Thermal Expansion Anjsotropy in AI2O3 ,” J. Am. Ceram. Soc, 65, 3, 174–78 (1982).Google Scholar